Cassette Lamp
By Neville Sukhia, photographer
You will need
12 cassettes, a square wooden block, super glue, a 10 watt light bulb, a bulb holder, electric wire with plug
How to
- Place the bulb
holder attached with electric wire at the centre of the wooden block. Drill and screw into place.
- With all sides
touching, glue the cassettes to form a square block, three levels high
- Fix the bulb into
the holder. Place the hollow
cassette block over the bulb. Grab a cup of tea on a rainy evening and let the nostalgic lamp set the
mood.
Cassette
Lamp
How
to
Cutout Maxi
By Ruhi Sheikh, content strategist at www.republicofchic.in
You will need
A jersey maxi, screws, bolts, washers,
fabriccutting scissors, tailor’s
chalk, eyelet punch tool
How to
- Use the tailor’s
chalk to make a straight line a
few inches below the bust. Mark matching
points above and below the drawn line; cut along the line.
- Take the eyelet
punch tool and make holes on the
marked points on the front and
back of both the separated pieces.
- Place a washer on
each hole, slip the screw
through and take it out on the corresponding
hole on the lower half of the dress.
Put in another washer and secure it with a bolt. Continue till top and lower half are completely attached in a full circle. With the noir goth trend looming over us this A/W,
you have the perfect reason to break in this tough-as-nails dress.
Cutout
Maxi
You
will need
How
to
Dupatta Gilet
By Nachiket Barve, fashion designer
You will need
A georgette dupatta, fabric-cutting scissors, tailor’s chalk, measuring tape, tacking pins, ribbon finishing trim, sewing needle, thread
How to
- Use the chalk to
mark the centre of the dupatta.
From the woven end, mark 10”
down. On either side of the centre line, mark 8”. At the point where the 8” mark
and 10” mark meet, draw an 8” line.
- Shape an oval keeping the 8” line in the centre to
use as the armhole. Fold on the
line and tack both the layers with pins to hold in place. Cut along the oval line; follow the same for the other armhole.
- Place the ribbon
finishing trim along the newly
cut armhole and stitch to form a
piped edge. Use it as a coloured
layer.
Dupatta
Gilet
You
will need
How
to
Earring Holder
By Rohima Sequeira, home makeover specialist
You will need
A carved wooden picture frame, acrylic oil paint, paint brush, lace fabric, staple gun, twine
How to
- Roughly brush the
paint onto the frame.
- On the back of the frame, staple the lace along
the inside edge, pulling the
fabric tight.
- Loop the twine
through the upper end of the
frame. Hang your favourite danglers on the wall.
Earring
Holder
You
will need
How
to
